Rogue-audio M-120 User Manual

THE ROGUE AUDIO MISSION ... At Rogue Audio we design and manufacture vacuum tube amplifiers. There is fierce competition in this market and

OPERATING YOUR AMPLIFIER 1) Powering up the system - First turn on the amplifier by pushing in the “power” button. The red LED will light after seve

4) Allign Tubes - Using a glove or a clean dry cloth, straighten any tubes that may have tilted during shipment as shown in figure 3. Ensure that tub

IF THERE IS A PROBLEM Below is a checklist of possible solutions if any problems are encountered. IF THERE IS NO SOUND 1) Check that all input

1) Remove Shipping Pallet - The amplifier is shipped attached to a shipping pallet. This pallet serves two purposes. First, and foremost it acts to t

OWNER AND WARRANTY REGISTRATION FORM Included with this manual is an Owner and Warranty Registration Form. Please take a minute to fill out this card

TABLE OF CONTENTS 1) Introduction 1 2) Setting up your power amplifier 1 3) Operating your power amplifier 8 4) Maintenance

THE ROGUE AUDIO MISSION ... At Rogue Audio we design and manufacture vacuum tube amplifiers. There is fierce competition in this market and

TABLE OF CONTENTS 1) Introduction 1 2) Setting up your power amplifier 1 3) Operating your power amplifier 8 4) Maintenance

OWNER AND WARRANTY REGISTRATION FORM Included with this manual is an Owner and Warranty Registration Form. Please take a minute to fill out this card

1) Remove Shipping Pallet - The amplifier is shipped attached to a shipping pallet. This pallet serves two purposes. First, and foremost it acts to t

IF THERE IS A PROBLEM Below is a checklist of possible solutions if any problems are encountered. IF THERE IS NO SOUND 1) Check that all input

4) Allign Tubes - Using a glove or a clean dry cloth, straighten any tubes that may have tilted during shipment as shown in figure 3. Ensure that tub

OPERATING YOUR AMPLIFIER 1) Powering up the system - First turn on the amplifier by pushing in the “power” button. The red LED will light after seve

8) Attach Power Cord - Connect the IEC end of detachable power cord to the amplifier, and plug opposite end into corresponding outlet. See Figure 4.

8) Attach Power Cord - Connect the IEC end of detachable power cord to the amplifier, and plug opposite end into corresponding outlet. See Figure 4.